 |
|
|
|
|
|
|
|
 |
 |
 |
 |
 |
 |
 |
|
| NOMENCLATURE |
TEXTILE CONVEYOR BELT |
|
| Example: 1000 m DIN 22102 AB 1000 EP 630/4 6/2 Y | |
| 1000 m | Length |
| DIN 22102 | Applicable standard/norm |
| AB | Manufacturer's acronym |
| 1000 | Belt width in mm |
| EP | Carcass material (polyester warp / polyamide weft) |
| 630 | Belt's minimum breaking strength in N/mm |
| 4 | Number of plies |
| 6 | Top cover thickness in mm |
| 2 | Bottom cover thickness in mm |
| Y | Rubber cover grade |
* Note 1: In some regions, PN is used instead of EP, where P stands for Polyester and N for Nylon. However, Nylon is a trademark, not a scientific term. ** Note 2: For textile conveyor belts it should additionally be indicated whether solid rubber edges or cut edges are preferred. |
|
STEEL CORD CONVEYOR BELT |
|
| Example: 2000 m DIN 22131 PH 1200 St 1600 7T/5 X | |
2000 m |
Length |
DIN 22131 |
Applicable standard/norm |
PH |
Manufacturer's acronym |
1200 |
Belt width in mm |
St |
Carcass material (steel cords) |
1600 |
Belt's minimum breaking strength in N/mm |
7 |
Top cover thickness in mm |
T |
Textile reinforcement (in top cover) |
5 |
Bottom cover thickness in mm |
X |
Rubber Cover grade |
| Note: A requirement of DIN standards for steel cord conveyor belts is that the breaking force of a vulcanized steel cord in the conveyor belt shall be at least as great as the product of the minimum breaking strength of the conveyor belt by the cord spacing with an addition of approximately 10%. | |